Toyota CH-R Service Manual: Navigation / Multi Info Display
Toyota CH-R Service Manual / Navigation / Multi Info Display
- Antenna Cord
- Navigation Antenna
- Navigation Ecu
- Navigation System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- System Description
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Data List / Active Test
- Air Conditioner ECU Vehicle Information Reading/Writing Processor Malfunction (B15F5)
- Diagnostic Trouble Code Chart
- Main Body ECU Vehicle Information Reading/Writing Process Malfunction (B15F6)
- Certification ECU Vehicle Information Reading/Writing Process Malfunction (B15F7)
- XM Tuner Antenna Disconnected (B15FE,B15FF)
- Sending Malfunction (Navigation to APGS) (U0073,U0100,U0129,U0140,U0155,U0164,U0198)
- Speaker Output Short (B15C3)
- Telematics Transceiver Disconnected (B15DB)
- Speed Signal Malfunction (B15C2)
- GPS Antenna Connection Malfunction(short) (B15C0,B15C1)
- Navigation Processor Malfunction (B15AD)
- AV Signal Stoppage (Low Battery Voltage) (B158F)
- USB Device Malfunction (B1585)
- Voice Recognition Microphone Disconnected (B1579)
- HD Radio Tuner Malfunction (B1551,B158D,B15B0,B15B3,B15B7,B15BA)
- Extension Module Malfunction 2 (B1556)
- Extension Module Disconnected 2 (B1543)
- Lost Communication with Meter (B1324)
- GVIF Disconnected (from Extension Module to H/U) (B153A)
- Satellite Radio Broadcast cannot be Received
- Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory
- Weather and traffic information cannot be obtained
- No Sound can be Heard from Speakers
- Noise Occurs
- Radio Broadcast cannot be Received or Poor Reception
- Illumination for Panel Switch does not Come on with Tail Switch ON
- Display does not Dim when Light Control Switch is Turned ON
- Panel Switches do not Function
- Touch Panel Switch does not Function
- Screen Flicker or Color Distortion
- Poor Sound Quality in All Modes (Low Volume)
- "No GPS signal" mark is displayed
- Cursor or Map Rotates when Vehicle Stopped
- Voice Guidance does not Function
- Route cannot be Calculated
- Voice is not Recognized
- Cellular Phone Registration Failure
- Cellular Phone Inspection
- Sound of Portable Player cannot be Heard from Speakers or Sound is Low
- Does not Play even after Bluetooth Audio Mode is Selected
- Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device
- Noise Occurs or Sound Skips when Portable Player Plays
- Portable Player cannot be Connected Manually/Automatically
- Registered Device cannot be Deleted
- Portable Player cannot be Registered
- USB Audio System Recognition/Play Error
- Black Screen
- Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
- Steering Pad Switch Circuit
- Illumination Circuit
- Parking Brake Switch Circuit
- Speaker Circuit
- Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
- Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
- Mute Signal Circuit between Radio Receiver and Telematics Transceiver
- Vehicle Speed Signal Circuit between Navigation ECU and Combination Meter
- Reverse Signal Circuit
- Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU
- Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU
- Microphone Circuit
- Radio Receiver Power Source Circuit
DCM Data Signal Circuit between Navigation ECU and DCM
DESCRIPTION
This circuit is used to send and receive signals between the DCM (Telematics
Transceiver) and radio and display receiver assembly.
WIRING DIAGRAM
PROCEDURE
1.
...
Antenna Cord
Components
COMPONENTS
ILLUSTRATION
*1
ANTENNA CORD SUB-ASSEMBLY
*2
NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
ILLUSTRATION
*A ...
Other materials:
Toyota CH-R Service Manual > Navigation System: "No GPS signal" mark is displayed
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or
maintenance, performing initialization, registration or calibration may
be needed. Refer to Precaution for Navigation System.
Click here
When replacing the radio ...
Toyota CH-R Service Manual > Blind Spot Monitor System: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION
This DTC is stored when a beam axis adjustment has not been performed for the
blind spot monitor sensor RH (Slave).
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose
of this DTC is to ensure that a beam axis adjustment is performed. Completin ...
Toyota C-HR (AX20) 2023-2026 Owner's Manual
Toyota CH-R Owners Manual
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Toyota CH-R Service Manual
- Introduction
- Maintenance
- Audio / Video
- Cellular Communication
- Navigation / Multi Info Display
- Park Assist / Monitoring
- Brake (front)
- Brake (rear)
- Brake Control / Dynamic Control Systems
- Brake System (other)
- Parking Brake
- Axle And Differential
- Drive Shaft / Propeller Shaft
- K114 Cvt
- 3zr-fae Battery / Charging
- Networking
- Power Distribution
- Power Assist Systems
- Steering Column
- Steering Gear / Linkage
- Alignment / Handling Diagnosis
- Front Suspension
- Rear Suspension
- Tire / Wheel
- Tire Pressure Monitoring
- Door / Hatch
- Exterior Panels / Trim
- Horn
- Lighting (ext)
- Mirror (ext)
- Window / Glass
- Wiper / Washer
- Door Lock
- Heating / Air Conditioning
- Interior Panels / Trim
- Lighting (int)
- Meter / Gauge / Display
- Mirror (int)
- Power Outlets (int)
- Pre-collision
- Seat
- Seat Belt
- Supplemental Restraint Systems
- Theft Deterrent / Keyless Entry
© 2017-2026 Copyright www.tochr.net
0.0193
0.0193