Toyota CH-R Service Manual: Noise Occurs or Sound Skips when Portable Player Plays

Toyota CH-R Service Manual / Navigation / Multi Info Display / Navigation System / Noise Occurs or Sound Skips when Portable Player Plays

CAUTION / NOTICE / HINT

HINT:

  • Perform this check with the portable player volume set at an appropriate level.
  • Make sure that there are no obstructions between the portable player and the radio and display receiver assembly that may block signals, and that the portable player and the radio and display receiver assembly are not excessively far apart.
  • Make sure that devices other than the radio and display receiver assembly are not connected to the portable player.
  • Make sure that there is no interference from a wireless LAN, etc.

PROCEDURE

1.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the same problem does not occur in the sound heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.

OK:

The same problem does not occur in the sound heard from the speakers.

NG

MALFUNCTION IN PORTABLE PLAYER

OK

2.

REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES

(a) Remove additional devices which use radio waves.

(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.

OK:

The same problem does not occur in the sound heard from the speakers.

OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device
    PROCEDURE 1. CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL (a) Check if track information is displayed normally on another "Bl ...

    Portable Player cannot be Connected Manually/Automatically
    CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assemb ...

    Other materials:

    Toyota CH-R Service Manual > Continuously Variable Transaxle System: Output Speed Sensor Circuit No Signal (P0722,P077C,P077D)
    DESCRIPTION The ECM receives a signal from the transmission revolution sensor (NOUT) installed in the continuously variable transaxle and determines the output shaft (secondary pulley) speed in order to control the gear ratio. The transmission revolution sensor (NOUT) detects the continuously ...

    Toyota CH-R Service Manual > Lin Communication System: Terminals Of Ecu
    TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *A 1 Connector Type - - *A 2 Connector Type - - (a) Disconnect the MB mai ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0108