Toyota CH-R Service Manual: Alignment / Handling Diagnosis

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. ...

Front Wheel Alignment

...

Other materials:

Toyota CH-R Service Manual > Blind Spot Monitor System: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor LH (Master). HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completi ...

Toyota CH-R Owners Manual > Steps to take in an emergency: If a warning light turns on or a warning buzzer sounds
Calmly perform the following actions if any of the warning lights comes on or flashes. If a light comes on or flashes, but then goes off, this does not necessarily indicate a malfunction in the system. However, if this continues to occur, have the vehicle inspected by your Toyota dealer. Warn ...