DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
U0073 |
Sending Malfunction (Navigation to APGS) |
CAN bus connection error |
CAN communication system |
|
U0100 |
Engine ECU Communication |
CAN reception error |
CAN communication system |
|
U0129 |
VSC(ECB)ECU Communication |
CAN reception error |
CAN communication system |
|
U0140 |
Lost Communication with Body Control Module |
CAN reception error |
CAN communication system |
|
U0155 |
Meter ECU Communication |
CAN reception error |
CAN communication system |
|
U0164 |
Air Conditioner ECU Communication |
CAN reception error |
CAN communication system |
|
U0198 |
Lost Communication with Telematic Control Module |
CAN reception error |
CAN communication system |
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Recheck for DTCs and check that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTCs are output.
| OK | |
USE SIMULATION METHOD TO CHECK |
| NG | |
GO TO CAN COMMUNICATION SYSTEM |
XM Tuner Antenna Disconnected (B15FE,B15FF)
Speaker Output Short (B15C3)Toyota CH-R Service Manual > Smart Key System(for Entry Function): Open in Front Passenger Side Electrical Antenna Circuit (B27A2)
DESCRIPTION
The certification ECU (smart key ECU assembly) generates a request signal and
transmits the signal to the front door outside handle assembly RH (electrical key
antenna) at intervals of 0.25 seconds. For the front door outside handle assembly
RH (electrical key antenna) to detect w ...
Toyota CH-R Service Manual > Rear Disc Brake Pad(for Tmmt Made): Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
The following procedure is for the LH side.
Use the same procedure for the RH side and LH side.
PROCEDURE
1. PRECAUTION
Click here
2. REMOVE REAR WHEEL
Click here
3. PERFORM REAR BRAKE PAD REPLACEMENT MODE
Click here
4. D ...