Toyota CH-R Service Manual: No Sound can be Heard from Speakers

PROCEDURE

1.

CHECK AUDIO SETTINGS

(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Weather and traffic information cannot be obtained
    CAUTION / NOTICE / HINT NOTICE: When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another ...

    Noise Occurs
    PROCEDURE 1. CHECK NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise sou ...

    Other materials:

    Toyota CH-R Service Manual > Continuously Variable Transaxle System: Acceleration Sensor Circuit (P1585)
    DESCRIPTION The ECM determines the vehicle inclination based on a signal from the airbag sensor assembly (yaw rate and acceleration sensor). If a malfunction in the airbag sensor assembly (yaw rate and acceleration sensor) is determined based on a malfunction signal from the skid control ECU ...

    Toyota CH-R Service Manual > Vacuum Pump: Installation
    INSTALLATION PROCEDURE 1. INSTALL VACUUM PUMP ASSEMBLY (a) When installing a new vacuum pump assembly: (1) Apply engine oil to the No. 2 O-ring and No. 3 O-ring which are installed to a new vacuum pump assembly. ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0105