Toyota CH-R Service Manual: Noise Occurs

Toyota CH-R Service Manual / Navigation / Multi Info Display / Navigation System / Noise Occurs

PROCEDURE

1.

CHECK NOISE CONDITION

(a) Check from which direction the noise comes (front left or right, or rear left or right).

OK:

The location of the noise source can be determined.

NG

GO TO STEP 3

OK

2.

CHECK SPEAKERS

(a) Check the installation condition of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other failures.

Result

Proceed to

No malfunction is found.

A

A speaker is installed incorrectly.

B

Foreign matter is in a speaker.

C

A speaker cone paper is broken.

D
B

REINSTALL SPEAKER
C

REMOVE FOREIGN MATTER
D

REPLACE SPEAKER
A

3.

CHECK NOISE CONDITIONS

(a) Check the noise condition.

HINT:

The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.

Condition under which Noise Occurs

Noise Source

Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped.

Generator

Noise occurs during A/C or heater operation.

Blower motor

Noise occurs when the horn switch is pressed and released or when pressed and held.

Horn

Noise occurs synchronously with the turn signal blinking pattern.

Flasher

Noise occurs during window washer operation.

Washer

Noise occurs during wiper operation.

Wiper

Noise occurs when the brake pedal is depressed.

Stop light switch

Others

Static electricity

HINT:

  • In the left column of the table, find the situation that matches the customer's complaint. Then, in the right column, find the part that is causing the noise. Check the respective noise filter.
  • To save time and avoid a misdiagnosis, first make sure that the noise is not coming from outside the vehicle.
  • Troubleshoot noises in descending order of loudness.
  • Setting the radio to a frequency where no signal is received may make recognition of the noise problem easier.

Result

Proceed to

The noise source cannot be determined.

A

The noise source can be determined.

B
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPAIR OR REPLACE NOISE SOURCE
    No Sound can be Heard from Speakers
    PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: A ...

    Radio Broadcast cannot be Received or Poor Reception
    WIRING DIAGRAM for TMMT Made for TMC Made CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initializat ...

    Other materials:

    Toyota CH-R Service Manual > Can Communication System: Check Bus 5 Line for Short to +B
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when no resistance exists between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and ...

    Toyota CH-R Service Manual > Smart Key System(for Entry Function): Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART Smart Key System (for Entry Function) DTC No. Detection Item Link B27A1 Open in Driver Side Electrical Antenna Circuit B27A2 Open in Front Passenger Side Electrical A ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0098