CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
HINT:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
PROCEDURE
|
1. |
CHECK COVERAGE AREA |
(a) Check that the current position of the vehicle is within the HD weather and traffic or DCM communication function coverage area.
OK:
Vehicle is within coverage area.
| NG | |
MOVE TO WITHIN COVERAGE AREA |
|
|
2. |
CHECK SYMPTOMS |
(a) Check for symptoms (poor sound quality, sounds cannot be heard, etc.) during conventional FM radio broadcasting.
|
Result |
Proceed to |
|---|---|
|
Symptoms occur |
A |
|
Symptoms do not occur |
B |
| A | |
GO TO "RADIO BROADCAST CANNOT BE RECEIVED OR POOR RECEPTION" IN PROBLEM SYMPTOMS TABLE |
|
|
3. |
CHECK SYMPTOMS |
(a) Check for symptoms (Unable to connect to call center, etc.) with an ordinary safety connect.
|
Result |
Proceed to |
|---|---|
|
Symptoms occur |
A |
|
Symptoms do not occur |
B |
| A | |
GO TO "UNABLE TO CONNECT TO CALL CENTER" IN PROBLEM SYMPTOMS TABLE |
| B | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast
cannot be Added into Memory
No Sound can be Heard from SpeakersToyota CH-R Service Manual > Radio Antenna Cord: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY
(a) w/o Manual (SOS) Switch
(1) Engage the clamp and guide to temporarily install the No. 3 antenna
cord sub-assembly.
*A
...
Toyota CH-R Service Manual > Vehicle Stability Control System: Stop Light Switch OFF Stuck Malfunction (C1426)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives stop light switch signals
and uses them to determine whether or not the brakes are applied.
The skid control ECU (brake actuator assembly) has a detection circuit that it
uses to detect a short in the stop light input line or ...