Toyota CH-R Service Manual: Illumination for Panel Switch does not Come on with Tail Switch ON

NOTICE:

• Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

  Click here

• When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
  • A communication malfunction DTC may be stored.
  • The radio and display receiver assembly may not operate normally.

HINT:

• This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.
• Make sure to move the vehicle to a bright area before performing an operation check with the light control switch in the AUTO position.

Radio Broadcast cannot be Received or Poor Reception

WIRING DIAGRAM for TMMT Made for TMC Made CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initializat ...

Display does not Dim when Light Control Switch is Turned ON

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

Other materials:

Toyota CH-R Service Manual > Safety Connect System: Ignition Switch Signal Malfunction (B15C6)
DESCRIPTION If vehicle movement (10 km/h (6 mph) or more for 10 seconds) is detected based on the location data sent from the radio receiver assembly even when the telematics transceiver detects that the ignition switch is off, this DTC will be stored. DTC No. Detection I ...

Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted Air Conditioner Pressure Sensor): Refrigerant Shortage (B14B8)
DESCRIPTION This DTC is stored if the amount of refrigerant in the air conditioning system is insufficient. The air conditioning amplifier assembly receives the ambient temperature signal, refrigerant pressure signal, etc. from various sensors. Based on these signals, the air conditioning amp ...