Toyota CH-R Service Manual: Touch Panel Switch does not Function

NOTICE:

• Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

  Click here

• When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
  • A communication malfunction DTC may be stored.
  • The radio and display receiver assembly may not operate normally.

HINT:

• If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.
• Turn the engine switch on (ACC) or on (IG) with your hand touching the operating section, non-response may occur.

Panel Switches do not Function

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

Screen Flicker or Color Distortion

PROCEDURE 1. CHECK DISPLAY SETTING (a) Reset display settings (contrast, brightness) and check that the screen appears normal. OK: The display returns to normal. ...

Other materials:

Toyota CH-R Service Manual > Audio / Video: Roof Antenna
Components COMPONENTS ILLUSTRATION *1 ROOF ANTENNA ASSEMBLY *2 ANTENNA OUTER COVER *3 HOLDER *4 SEAL N*m (kgf*cm, ft.*lbf): Specified torque ● Non-re ...

Toyota CH-R Service Manual > Can Communication System: Check Bus 3 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and ...