Components
COMPONENTS
ILLUSTRATION
*1 |
ROOF ANTENNA ASSEMBLY |
*2 |
ANTENNA OUTER COVER |
*3 |
HOLDER |
*4 |
SEAL |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
Removal
REMOVAL
PROCEDURE
1. REMOVE ROOF HEADLINING
Click here
2. REMOVE ROOF ANTENNA ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the bolt and holder. |
|
(c) Remove the roof antenna assembly with antenna outer cover as shown in the illustration.
![]() |
Remove in this Direction |
(d) Disengage the claws and guides to remove the roof antenna assembly as shown in the illustration.
![]() |
Remove in this Direction (1) |
![]() |
Remove in this Direction (2) |
(e) When reusing the roof antenna assembly
![]() |
Remove in this Direction |
(1) Remove the seal as shown in the illustration.
Installation
INSTALLATION
PROCEDURE
1. INSTALL ROOF ANTENNA ASSEMBLY
(a) When reusing the roof antenna assembly
![]() |
Install in this Direction |
(1) Install a new seal as shown in the illustration.
(b) Engage the guides and claws to install the roof antenna assembly as shown in the illustration.
![]() |
Install in this Direction (1) |
![]() |
Install in this Direction (2) |
(c) Install the roof antenna assembly with antenna outer cover as shown in the illustration.
![]() |
Install in this Direction |
(d) Install a new holder with the new bolt.
Torque:
9.5 N·m {97 kgf·cm, 84 in·lbf}
(e) Connect the connector.
2. INSTALL ROOF HEADLINING
Click here
Toyota CH-R Service Manual > Seat Belt Warning System(w/ Occupant Classification System): Front Passenger Side Seat Belt Warning Light Malfunction
DESCRIPTION
When the ignition switch is turned ON, the occupant detection ECU sends signals
to the airbag sensor assembly to indicate the state of the front seat inner belt
assembly RH and also whether the front passenger seat is occupied. The airbag sensor
assembly sends those signals to the ...
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Security Indicator Light Does not Blink
DESCRIPTION
The transponder key ECU assembly blinks the security indicator light when the
immobiliser is set.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
If the transponder key ECU assembly is replaced, refer to Registration.
Click here
PROCEDURE
1.
SYSTEM CHE ...