SYSTEM DESCRIPTION
ILLUMINATED ENTRY SYSTEM
(a) The illuminated entry system has the following control functions:
Control |
Outline |
Lights that Operate |
---|---|---|
Actuation Area-linked*1 |
When a registered key is brought within any vehicle exterior detection area around the doors, the items listed to the right turn on. |
|
Door Lock/Unlock-linked |
When any door is unlocked, the lights that operate turn on. |
|
When the all doors is locked, the lights that operate turn off. |
||
Door Open/Close-linked |
When any door is opened, the lights that operate turn on. |
|
When the ignition switch is turned to ACC or ON and all doors are closed, the lights that operate turn off. |
|
|
Engine Switch-linked*1 |
When the engine switch is turned from on (ACC or IG) to off, the lights that operate turn on. |
|
Ignition Switch-linked*2 |
When the ignition switch is turned from ACC or ON to off, the lights that operate turn on. |
|
Shift Position-linked*3 |
When the shift lever is moved from P to any other position, the lights that operate dim. |
|
Delay |
When approximately 15 seconds elapse after the following condition is met, the lights that operate turn off (*1):
|
|
When approximately 15 seconds elapse after the following condition is met, the lights that operate turn off:
|
|
|
When approximately 15 seconds elapse after either of the following conditions is met, the lights that operate turn off:
|
|
BATTERY SAVING CONTROL SYSTEM
(a) The battery saving control system has the following control functions:
Control |
Outline |
Lights that Operate |
---|---|---|
Basic function |
When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off. HINT: Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.
|
|
Interior light auto cut function |
When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off. HINT: Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.
|
|
Toyota CH-R Service Manual > Lumbar Switch: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT LUMBAR POWER SEAT SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condit ...
Toyota CH-R Service Manual > Rear Combination Light Assembly(for Bulb Type): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR COMBINATION LIGHT ASSEMBLY
(a) Connect the connector.
(b) Engage the guide, pin and clip to temporarily instal ...