CAUTION / NOTICE / HINT
HINT:
PROCEDURE
|
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
|
2. |
CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK |
|
|
3. |
INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
|
4. |
INSPECT CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
|
Result |
Proceed to |
|---|---|
|
CAN communication system DTCs are not output. |
A |
|
CAN communication system DTCs are output. |
B |
| B | |
GO TO CAN COMMUNICATION SYSTEM |
|
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
|
Result |
Proceed to |
|---|---|
|
Fault is not listed in Problem Symptoms Table. |
A |
|
Fault is listed in Problem Symptoms Table. |
B |
| B | |
GO TO PROBLEM SYMPTOMS TABLE |
|
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test
Click here
(b) Terminals of ECU
Click here
|
|
7. |
ADJUST, REPAIR OR REPLACE |
|
|
8. |
CONFIRMATION TEST |
| NEXT | |
END |
System Diagram
System DescriptionToyota CH-R Service Manual > Park Assist / Monitoring: Blind Spot Monitor Sensor
Components
COMPONENTS
ILLUSTRATION
*1
BLIND SPOT MONITOR BRACKET LH
*2
BLIND SPOT MONITOR BRACKET RH
*3
BLIND SPOT MONITOR SENSOR LH
*4
BLIND SPOT MONITOR SENSOR RH
N*m (kgf ...
Toyota CH-R Service Manual > Vehicle Stability Control System: Slip Indicator Light does not Come ON
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination
meter assembly via CAN communication.
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform system
variant learning.
Click here
PROCEDURE
...