Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR SPEAKER ASSEMBLY

(a) Engage the claw and guide to temporarily install the rear speaker assembly.

(b) Using an air riveter or a hand riveter, install the rear speaker assembly with 3 new rivets order show in the illustration.

*a

Incorrect

*b

Correct

*c

Riveter

*d

Mandrel

NOTICE:

  • Do not touch the speaker cone.
  • Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.
  • Confirm that the rivets are seated properly against the speaker.
  • Do not tilt the riveter when installing the speaker with the rivets.
  • Do not leave any space between the rivet heads and speaker.
  • Do not leave any space between the speaker and door. Firmly hold the speaker and door together while installing the rivets.

HINT:

If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

(c) Connect the connector.

2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Click here

3. INSTALL REAR DOOR REAR FRAME BRACKET

Click here

4. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

Click here

5. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Click here

    Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR SPEAKER ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: ...

    Roof Antenna
    Components COMPONENTS ILLUSTRATION *1 ROOF ANTENNA ASSEMBLY *2 ANTENNA OUTER COVER *3 HOLDER *4 SEA ...

    Other materials:

    Toyota CH-R Service Manual > Automatic Headlight Beam Level Control System: Parts Location
    PARTS LOCATION ILLUSTRATION *1 BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU) *2 HEADLIGHT UNIT ASSEMBLY LH - HEADLIGHT LEVELING MOTOR *3 HEADLIGHT UNIT ASSEMBLY RH - HEADLIGHT LEVELING MOTOR *4 HEADL ...

    Toyota CH-R Service Manual > Continuously Variable Transaxle System: System Description
    SYSTEM DESCRIPTION SYSTEM DESCRIPTION (a) The K114 (CVT) is a fully electrohydraulically controlled steel belt type continuously variable transaxle. This is a highly efficient transaxle that is controlled in conjunction with the engine, contributing to enhanced fuel efficiency and quietness ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0064