Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR SPEAKER ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (+) - 2 (-)

Always

4.0 Ω

If the result is not as specified, replace the rear speaker assembly.

*a

Component without harness connected

(Rear Speaker Assembly)

    Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR DOOR INSIDE HANDLE ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR SPEAKER ASSEM ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: Test Mode Procedure
    TEST MODE PROCEDURE WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK (a) When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light (red indicator), VSC OFF indicator light, multi-information display (TRAC OFF message) (for Color TFT Type), TRAC OFF i ...

    Toyota CH-R Service Manual > Can Communication System: Check Bus 3 Line for Short to +B
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when no resistance exists between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and t ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0124