Toyota CH-R Service Manual: Route cannot be Calculated

PROCEDURE

1.

SET DESTINATION

(a) Set another destination and check if the system can calculate the route correctly.

OK:

Route can be correctly calculated.

OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Voice Guidance does not Function
    WIRING DIAGRAM PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance setting is not off. OK: Voice guidance setting is not off. NG ...

    Voice is not Recognized
    PROCEDURE 1. CHECK CONDITION (a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation. OK: Voice command is ...

    Other materials:

    Toyota CH-R Service Manual > Blind Spot Monitor System: Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the blind spot monitor system on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Code ...

    Toyota CH-R Service Manual > Introduction: How To Use This Manual
    General Information GENERAL INFORMATION GENERAL DESCRIPTION (a) Repair operations can be separated mainly into the following 3 processes: (1) Diagnosis. (2) Removing/Installing, Replacing, Disassembling/Reassembling, Checking and Adjusting. (3) Final Inspection. (b) The following procedur ...

    © 2017-2021 Copyright www.tochr.net
    0.0209