Toyota CH-R Service Manual: Voice is not Recognized

HINT:

• When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Cancel" is spoken, "Cancel" is displayed in the voice recognition result display area.)
• If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
• The system cannot recognize voice commands when multiple people are speaking simultaneously.
• If the speaking speed is too fast or too slow, the recognition rate may decrease.
• The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).

Route cannot be Calculated

PROCEDURE 1. SET DESTINATION (a) Set another destination and check if the system can calculate the route correctly. OK: Route can be correctly calculated. ...

Cellular Phone Registration Failure

CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

Other materials:

Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Terminals Of Ecu
TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY (a) Disconnect the F22 transponder key ECU assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. ...

Toyota CH-R Service Manual > Smart Key System(for Entry Function): Open in Driver Side Electrical Antenna Circuit (B27A1)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the front door outside handle assembly LH (electrical key antenna) at intervals of 0.25 seconds. For the front door outside handle assembly LH (electrical key antenna) to detect w ...