Toyota CH-R Service Manual: Extension Module Malfunction 2 (B1556)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the Navigation ECU.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B1556

Extension Module Malfunction 2

When any of the following conditions is met:

  • Internal power supply malfunction
  • Internal hard drive malfunction
  • EEPROM error
  • Storage malfunction

Navigation ECU

CAUTION / NOTICE / HINT

NOTICE:

When replacing the navigation ECU, always replace it with a new one. If a navigation ECU which was installed to another vehicle is used, the following may occur:

  • A communication malfunction DTC may be stored.
  • The navigation ECU may not operate normally.

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE NAVIGATION ECU

    HD Radio Tuner Malfunction (B1551,B158D,B15B0,B15B3,B15B7,B15BA)
    DESCRIPTION These DTCs are stored when a malfunction occurs in the radio and display receiver assembly. DTC No. Detection Item DTC Detection Condition T ...

    Extension Module Disconnected 2 (B1543)
    DESCRIPTION If the radio and display receiver assembly cannot detect the navigation ECU for a certain period of time (90 seconds) after the engine switch is turned on (ACC) and the radio and disp ...

    Other materials:

    Toyota CH-R Service Manual > Continuously Variable Transaxle Assembly(when Using The Engine Support Bridge): Components
    COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER *2 REAR ENGINE UNDER COVER LH *3 REAR ENGINE UNDER COVER RH - - N*m (kgf*cm, ft.*lbf): Specified torque - ...

    Toyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Reverse Signal Circuit
    DESCRIPTION The radio and display receiver assembly receives a reverse signal from the park/neutral position switch. WIRING DIAGRAM PROCEDURE 1. CHECK BACK-UP LIGHT (a) Move the shift lever to R and check if the back-up lights come on. OK: The back-up ligh ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0091