PROCEDURE
|
1. |
CHECK CONDITION |
|
(a) Check with the customer if the vehicle has been turned by a turntable. OK: Vehicle has not been turned by a turntable. HINT: If the vehicle is turned on a turntable with the engine switch on (IG), the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the engine switch off and back to on (IG) again with the vehicle completely stopped. |
|
| OK | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | |
TURN ENGINE SWITCH ON (IG) WHEN VEHICLE IS COMPLETELY STOPPED |
"No GPS signal" mark is displayed
Voice Guidance does not FunctionToyota CH-R Service Manual > Front Shock Absorber: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT LOWER COIL SPRING INSULATOR
(a) Install the front lower coil spring insulator to the front shock absorber
as ...
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
DESCRIPTION
The CVT fluid temperature sensor converts the fluid temperature into a resistance
value which is detected by the ECM.
The sensor resistance changes with the CVT fluid temperature. As the temperature
rises, the sensor resistance decreases. The ECM applies voltage to the temperature ...