Toyota CH-R Service Manual: Precaution

PRECAUTION

PRECAUTION FOR NAVIGATION SYSTEM

NOTICE:

  • When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly or navigation ECU may not operate normally.
  • When replacing the DCM (telematics transceiver), make sure to replace it with a new one.
  • After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.
  • After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.

(a) If any of the following parts are replaced, refer to Initialization in Repair Instruction.

Click here

  • Radio and display receiver assembly*1
  • DCM (telematics transceiver)
  • *1: After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, SiriusXM radio ID registration is necessary (w/ SXM Function).
    Navigation System
    ...

    Parts Location
    PARTS LOCATION ILLUSTRATION *1 MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY) *2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) *3 ...

    Other materials:

    Toyota CH-R Service Manual > Power Window Regulator Motor(for Front Door): Inspection
    INSPECTION CAUTION / NOTICE / HINT NOTICE: Do not apply positive (+) battery voltage to any terminals, except terminal 2 (B), to avoid damaging the pulse sensor inside the motor. Perform initialization of the power window system after removing, inspecting or replacing the powe ...

    Toyota CH-R Service Manual > Rear Shock Absorber: Disposal
    DISPOSAL PROCEDURE 1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY (a) Extend the piston rod and secure the rear shock absorber assembly at an angle in a vise. (b) Using a hacksaw, slowly make a hole at the position indicated by the arrow ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0098