DIAGNOSTIC TROUBLE CODE CHART
Navigation System|
DTC No. |
Detection Item |
Link |
|---|---|---|
|
B1324 |
Lost Communication with Meter |
|
|
B153A |
GVIF Disconnected (from Extension Module to H/U) |
|
|
B1543 |
Extension Module Disconnected 2 |
|
|
B1551 |
HD Radio Tuner Malfunction |
|
|
B1556 |
Extension Module Malfunction 2 |
|
|
B1579 |
Voice Recognition Microphone Disconnected |
|
|
B1585 |
USB Device Malfunction |
|
|
B158D |
Video Signal Stoppage |
|
|
B158F |
AV Signal Stoppage (Low Battery Voltage) |
|
|
B15AD |
Navigation Processor Malfunction |
|
|
B15B0 |
Display Screen Malfunction |
|
|
B15B3 |
Radio Tuner Malfunction |
|
|
B15B7 |
Bluetooth Module Malfunction |
|
|
B15BA |
XM Tuner Malfunction |
|
|
B15C0 |
GPS Antenna Connection Malfunction(short) |
|
|
B15C1 |
GPS Antenna Connection Malfunction(break) |
|
|
B15C2 |
Speed Signal Malfunction |
|
|
B15C3 |
Speaker Output Short |
|
|
B15DB |
Telematics Transceiver Disconnected |
|
|
B15F5 |
Air Conditioner ECU Vehicle Information Reading/Writing Processor Malfunction |
|
|
B15F6 |
Main Body ECU Vehicle Information Reading/Writing Process Malfunction |
|
|
B15F7 |
Certification ECU Vehicle Information Reading/Writing Process Malfunction |
|
|
B15FE |
XM Tuner Antenna Disconnected |
|
|
B15FF |
XM Tuner Antenna Short |
|
|
U0073 |
Sending Malfunction (Navigation to APGS) |
|
|
U0100 |
Engine ECU Communication |
|
|
U0129 |
VSC(ECB)ECU Communication |
|
|
U0140 |
Lost Communication with Body Control Module |
|
|
U0155 |
Meter ECU Communication |
|
|
U0164 |
Air Conditioner ECU Communication |
|
|
U0198 |
Lost Communication with Telematic Control Module |
|
Air Conditioner ECU Vehicle Information Reading/Writing Processor Malfunction
(B15F5)
Main Body ECU Vehicle Information Reading/Writing Process Malfunction (B15F6)Toyota CH-R Service Manual > Pre-collision System: Operation Check
OPERATION CHECK
CHECK PRE-COLLISION SYSTEM SETTING
(a) Turn the ignition switch to ON.
(b) Operate the steering pad switch assembly to change the setting of PCS on
the multi-information display to "On" and check that the pre-collision system turns
on.
HINT:
When the ignition switc ...
Toyota CH-R Service Manual > Rear Stabilizer Bar: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR STABILIZER LINK ASSEMBLY
(a) Inspect the turning torque of the ball joint.
(1) Secure the rear stabilizer link assembly in a vise using aluminum plates.
NOTICE:
Do not overtighten the vise.
(2) Install the nut to the rear stabilizer link assembly stud.
...