Toyota CH-R Service Manual: Radio Antenna Cord

Installation

INSTALLATION PROCEDURE 1. INSTALL RADIO SETTING CONDENSER (a) Engage the claw to install a new terminal cover to the wire harness. NOTICE: Make sure to hold the crimpi ...

Components

COMPONENTS ILLUSTRATION *1 ANTENNA CORD SUB-ASSEMBLY *2 NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY ILLUSTRATION *A Ty ...

Other materials:

Toyota CH-R Service Manual > Blower Unit(for Denso Made): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...

Toyota CH-R Service Manual > Charging System: Charging Failure
PROCEDURE 1. CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION) (a) Start the engine and visually check that the generator rotor assembly (fan) in the generator assembly is operating. OK: The generator rotor assembly (fan) is operating. NG ...