PROCEDURE
1. |
CHECK DISPLAY SETTING |
(a) Reset display settings (contrast, brightness) and check that the screen appears normal.
OK:
The display returns to normal.
OK | ![]() |
END |
NG | ![]() |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Toyota CH-R Service Manual > Instrument Panel Safety Pad: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
instrument panel safety pad sub-assembly removal/installation are shown below.
Necessary Proced ...
Toyota CH-R Service Manual > Airbag System: TC and CG Terminal Circuit
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.
HINT:
When multiple warning lights in the combination meter blink continuously,
a short to ground in the wiring or an ECU connected to terminal T ...