CAUTION / NOTICE / HINT
NOTICE:
Click here
PROCEDURE
1. |
CHECK MULTI-DISPLAY |
(a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the multi-display.
HINT:
If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.
NG | ![]() |
REMOVE FOREIGN MATTER |
|
2. |
CHECK TOUCH PANEL |
(a) Check for foreign matter on the display.
OK:
The display is clean.
NG | ![]() |
CLEAN DISPLAY AND RECHECK TOUCH PANEL |
|
3. |
CHECK TOUCH SWITCH (OPERATION CHECK) |
(a) Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check. Click here
|
|
(b) Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
OK | ![]() |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
NG | ![]() |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Toyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound signal from an external
device to the radio and display receiver assembly via this circuit.
The sound signal that has been sent is amplified by the radio and display receiver
assembly and then is sent to the speakers.
If there ...
Toyota CH-R Service Manual > Vehicle Stability Control System: Low Power Supply Voltage Malfunction (C1241)
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU
(brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS
operation. This DTC is stored when the +BS terminal voltage meets one of the DTC
detection conditions due to a malfunct ...