Toyota CH-R Service Manual: Open in ABS Solenoid Relay Circuit (C146E)

Toyota CH-R Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Open in ABS Solenoid Relay Circuit (C146E)

DESCRIPTION

The ABS solenoid relay is built into the skid control ECU in the brake actuator assembly. The ABS solenoid relay supplies power to the ABS and TRAC solenoids. The skid control ECU detects a solenoid relay malfunction by performing a self check and relay operation check.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C146E

Open in ABS Solenoid Relay Circuit

Either of the following is detected:

  • A solenoid relay drive circuit in the skid control ECU is malfunctioning.
  • The solenoid relay cannot be switched between on and off.

ABS solenoid relay (brake actuator assembly)
DTC Detection Conditions: C146E
 

Vehicle Condition

Pattern 1

Pattern 2

Diagnosis Condition

-

-

-

Malfunction Status

A solenoid relay drive circuit in the skid control ECU is malfunctioning.

○

-

The solenoid relay cannot be switched between on and off.

-

○

Detection Time

-

-

Number of Trips

1 trip

1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform system variant learning.

Click here

PROCEDURE

1.

REPLACE BRAKE ACTUATOR ASSEMBLY

(a) Replace the ABS solenoid relay (brake actuator assembly).

Click here

NEXT

END
    Yaw Rate Sensor Output Value (C1448)
    DESCRIPTION The yaw rate and acceleration sensor is built into the airbag sensor assembly. The skid control ECU receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) ...

    Control Module Communication Bus OFF (U0073,U0100,U0123,U0126,U0142)
    DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the ECM, steering angle sensor, yaw rate and acceleration sensor (airbag sensor assembly) and main body ECU (multi ...

    Other materials:

    Toyota CH-R Service Manual > Safety Connect System: Telematics Transceiver Malfunction (B15A8)
    DESCRIPTION This DTC is set when an error in the EEPROM or PLL IC is detected on the DCM (Telematics Transceiver) self-check. The EEPROM (Electrically Erasable Programmable Read-Only Memory) stores the various data to operate the safety connect system. The PLL IC (Phase-Locked Loop Integrated ...

    Toyota CH-R Service Manual > Door Control Transmitter(w/ Smart Key System): Inspection
    INSPECTION PROCEDURE 1. INSPECT ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY (a) Inspect the operation of the electrical key transmitter sub-assembly. (1) Remove the transmitter battery from the electrical key transmitter sub-assembly. Click here (2) Install a new or known good transmitter batt ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0109