Toyota CH-R Service Manual: Hood

Fuel Lid Opener System

Parts Location PARTS LOCATION ILLUSTRATION *1 FUEL LID WITH MOTOR LOCK ASSEMBLY *2 NO. 1 ENGINE ROOM RELAY BLOCK - FUEL OPN FUSE ILLUSTR ...

Components

COMPONENTS ILLUSTRATION *1 HOLE PLUG *2 HOOD INSULATOR *3 HOOD SIDE PANEL LH *4 HOOD SIDE PANEL RH ...

Other materials:

Toyota CH-R Service Manual > Power Window Control System: Terminals Of Ecu
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the J6 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector ...

Toyota CH-R Service Manual > Compressor(for Valeo Made): Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor with pulley assembly with a new one, gradually discharge the refrigerant gas from the service valve. Then drain the following amount of oil from the new compressor with pulley assembly before ...