Toyota CH-R Service Manual: Reassembly

REASSEMBLY

PROCEDURE

1. CONNECT WASHER HOSE ASSEMBLY

(a) Install the 7 clamps.

(b) Connect the washer hose assembly to the clamps and guide.

*a	Clamp
*b	Guige

2. INSTALL WASHER NOZZLE SUB-ASSEMBLY

Click here

3. INSTALL HOLE PLUG

(a) Install 2 new hole plugs.

4. INSPECT WASHER NOZZLE SUB-ASSEMBLY

Click here

5. ADJUST WASHER NOZZLE SUB-ASSEMBLY

Click here

6. INSTALL HOOD INSULATOR

(a) Engage the guides to install the hood insulator.

(b) Install 8 new clips.

7. INSTALL HOOD SIDE PANEL LH

(a) Engage the clips to install a new hood side panel LH.

8. INSTALL HOOD SIDE PANEL RH

HINT:

Use the same procedure as for the LH side.

ADJUSTMENT CAUTION / NOTICE / HINT *a Centering Bolt *b Standard Bolt HINT: Centering bolts are used to install the hood hinges ...

...

Toyota CH-R Service Manual > Wiper And Washer System: Parts Location
PARTS LOCATION ILLUSTRATION *A w/ Rain Sensor *B for Cold Area Specification Vehicles *1 WINDSHIELD WIPER MOTOR ASSEMBLY *2 RAIN SENSOR *3 REAR WIPER MOTOR ASSEMBLY ...

Toyota CH-R Service Manual > Smart Key System(for Start Function): Power Source Mode does not Change to ON (IG and ACC)
DESCRIPTION If any of the following operations are performed, the certification ECU (smart key ECU assembly) receives a signal, and changes the power source mode. With the electrical key transmitter sub-assembly in the cabin, the engine switch is pressed. When the transmitter batt ...

Toyota C-HR (AX20) 2023-2025 Owner's Manual