Toyota CH-R Service Manual: Vacuum Warning Switch

Installation

INSTALLATION PROCEDURE 1. INSTALL VACUUM PUMP ASSEMBLY (a) When installing a new vacuum pump assembly: (1) Apply engine oil to the No. 2 O-ring and No. 3 O-ring which are installed ...

Components

COMPONENTS ILLUSTRATION *1 COWL BODY MOUNTING REINFORCEMENT LH *2 COWL BODY MOUNTING REINFORCEMENT RH *3 NO. 1 HEATER AIR DU ...

Other materials:

Toyota CH-R Service Manual > Power Steering System: Calibration
CALIBRATION TORQUE SENSOR ZERO POINT CALIBRATION (USING TECHSTREAM) NOTICE: Perform torque sensor zero point calibration if any of the following conditions occur: The power steering ECU assembly has been replaced. The electric power steering column sub-assembly has been replaced. ...

Toyota CH-R Service Manual > Steering Gear: Inspection
INSPECTION PROCEDURE 1. INSPECT TIE ROD END SUB-ASSEMBLY LH (a) Secure the tie rod end sub-assembly LH in a vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Install the nut to the stud bolt. (c) Flip the ...