COMPONENTS
ILLUSTRATION
|
*1 |
COWL BODY MOUNTING REINFORCEMENT LH |
*2 |
COWL BODY MOUNTING REINFORCEMENT RH |
|
*3 |
NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL |
*4 |
OUTER COWL TOP PANEL SUB-ASSEMBLY |
|
*5 |
WATER GUARD PLATE LH |
- |
- |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
|
*1 |
VACUUM WARNING SWITCH ASSEMBLY |
*2 |
CHECK VALVE GROMMET |
|
● |
Non-reusable part |
- |
- |
On-vehicle InspectionToyota CH-R Service Manual > Wheel Opening Moulding(for Rear): Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL NO. 1 BODY OUTSIDE MOULDING PAD
HINT:
When installing the No. 1 body outside moulding pad, heat the quarter outside
...
Toyota CH-R Service Manual > Toyota Entune System: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the Entune system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
...