INSTALLATION
PROCEDURE
1. INSTALL BACK DOOR LOCK ASSEMBLY
HINT:
Make sure to remove the string before installing a new back door lock assembly.
(a) Apply MP grease to the sliding parts of the back door lock assembly.
(b) Install the back door lock assembly with the 3 bolts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(c) Connect the connector.
2. INSTALL BACK DOOR LOCK COVER
Click here
3. INSTALL BACK DOOR TRIM PANEL ASSEMBLY
Click here
4. INSTALL BACK DOOR SIDE GARNISH LH
Click here
5. INSTALL BACK DOOR SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
6. INSTALL BACK DOOR TRIM UPPER PANEL ASSEMBLY
Click here
7. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Click here
8. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)
Click here
Toyota CH-R Owners Manual > Do-it-yourself maintenance: Air conditioning filter
The air conditioning filter must be changed regularly to maintain
air conditioning efficiency.
Removal method
1. Turn the engine switch off.
2. Open the glove box. Slide off the damper.
3. Push in each side of the glove box to disconnect the claws, and then slowly
and fully open the glov ...
Toyota CH-R Service Manual > Tire Pressure Warning System: ECU Power Source Circuit
DESCRIPTION
This is the power source for the tire pressure warning ECU and receiver.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the tire pressure warning ECU and receiver, read the
transmitter IDs stored in the old ECU using the Techstream and write them
dow ...