REMOVAL
PROCEDURE
1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)
Click here
2. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
Click here
3. REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY
Click here
4. REMOVE BACK DOOR SIDE GARNISH LH
Click here
5. REMOVE BACK DOOR SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
6. REMOVE BACK DOOR TRIM PANEL ASSEMBLY
Click here
7. REMOVE BACK DOOR LOCK COVER
Click here
8. REMOVE BACK DOOR LOCK ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 3 bolts and back door lock assembly. |
|
Toyota CH-R Service Manual > Continuously Variable Transaxle Assembly(when Not Using The Engine Support Bridge): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
continuously variable transaxle assembly removal/installation are shown below.
Necessary Proced ...
Toyota CH-R Service Manual > Side Airbag Sensor(for Front Door): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL DOOR SIDE AIRBAG SENSOR
(a) Check that the ignition switch off.
(b) Check that the cable is disconnected from the n ...