Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT BACK DOOR LOCK ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (ACT-) - 3 (D+)

Unlocked

Below 1 Ω

2 (ACT-) - 3 (D+)

Locked

10 kΩ or higher

If the result is not as specified, replace the back door lock assembly.

*a

Component without harness connected

(Back Door Lock Assembly)

*b

Lock

*c

Unlock

    Components
    COMPONENTS ILLUSTRATION *A w/ Package Tray Trim *B w/ Tonneau Cover *1 BACK DOOR LOCK ASSEMBLY *2 BACK ...

    Removal
    REMOVAL PROCEDURE 1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim) Click here 2. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Click here 3. REMOVE BACK DOOR TRIM UPP ...

    Other materials:

    Toyota CH-R Service Manual > Airbag System: Check Mode Procedure
    CHECK MODE PROCEDURE CHECK MODE (SIGNAL CHECK): DTC CHECK (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch ON. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / SRS Airbag / Utility / Signal Check. Body Electri ...

    Toyota CH-R Service Manual > Steering Gear: Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. (b) Install the No. 2 steering rack boot to the groove on the ra ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0065