DTC CHECK / CLEAR
NOTICE:
When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
HINT:
Refer to the Techstream operator's manual for further details.
CHECK FOR IMMOBILISER DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.
Body Electrical > Smart Key > Trouble Codes(e) Check for DTCs.
CHECK FOR ECM DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Powertrain > Engine and ECT > Trouble Codes(e) Check for DTCs.
CLEAR IMMOBILISER DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Smart Key / Clears Codes.
Body Electrical > Smart Key > Clear DTCs(e) Clear the DTCs.
CLEAR ECM DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine and ECT / Clears Codes.
Powertrain > Engine and ECT > Clear DTCs(e) Clear the DTCs.
Toyota CH-R Service Manual > Seat Belt Warning System(w/ Occupant Classification System): Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because intermittent conditions or signals may ...
Toyota CH-R Service Manual > Meter / Gauge System: Terminals Of Ecu
TERMINALS OF ECU
COMBINATION METER ASSEMBLY
(a) Disconnect the combination meter assembly connectors.
(b) Measure the voltage on the wire harness side connector according to the value(s)
in the table below.
Terminal No.
Wiring Color
Terminal Description
...