COMPONENTS
ILLUSTRATION
*A |
for Driver Side |
*B |
for Front Passenger Side |
*1 |
FRONT DOOR INSIDE HANDLE BEZEL PLUG |
*2 |
FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
*3 |
FRONT NO. 1 SPEAKER ASSEMBLY |
*4 |
MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL |
*5 |
POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL |
*6 |
RIVET |
● |
Non-reusable part |
- |
- |
Toyota CH-R Service Manual > Power Window Control System: Terminals Of Ecu
TERMINALS OF ECU
CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the J6 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the connector ...
Toyota CH-R Service Manual > Front Speed Sensor: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
The front speed sensor rotor is a component of the front axle hub sub-assembly.
If the front speed sensor rotor is malfunctioning, replace ...