DESCRIPTION
This DTC is output if the vehicle variation information is not written to the headlight ECU sub-assembly LH.
The headlight ECU sub-assembly LH outputs DTC B2451.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Note |
|---|---|---|---|---|
|
B2451 |
Vehicle Specifications have not been Stored |
Vehicle specification information not written |
Headlight ECU sub-assembly LH |
- |
CAUTION / NOTICE / HINT
NOTICE:
After the headlight ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.
Click here
PROCEDURE
|
1. |
VEHICLE INFORMATION HEADLIGHT ECU SUB-ASSEMBLY LH |
(a) Register vehicle information for the headlight ECU sub-assembly LH.
Click here
|
|
2. |
CLEAR DTC |
(a) Clear the DTCs.
Click here
|
|
3. |
CHECK FOR DTC |
(a) Turn the ignition switch to ON.
(b) Turn on the headlights using the light control switch.
(c) Check for DTCs.
Click here
|
Result |
Proceed to |
|---|---|
|
DTC B2451 output does not occur |
A |
|
DTC B2451 output occurs |
B |
| A | |
END (NORMAL AFTER VEHICLE INFORMATION REGISTERED) |
| B | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
Open in IG Circuit (B242E)
CAN Communication Failure (Message Registry) (U1000)Toyota CH-R Service Manual > Black Out Tape(for Front Door): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
the black out tape removal/installation are shown below.
Necessary Procedure After Parts Removed/ ...
Toyota CH-R Service Manual > Navigation System: Microphone Circuit
DESCRIPTION
The radio and display receiver assembly, map light assembly and telephone microphone
assembly are connected to each other using the microphone connection detection signal
lines.
Using this circuit, the DCM (telematics transceiver) sends power to the map light
assembly and telepho ...