Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT COMPRESSOR WITH PULLEY ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (SOL+) - 1 (SOL-)

20°C (68°F)

10.1 to 11.1 Ω

If the result is not as specified, replace the compressor with pulley assembly.

*a

Component without harness connected

(Compressor with Pulley Assembly)

    Components
    COMPONENTS ILLUSTRATION *1 COMPRESSOR WITH PULLEY ASSEMBLY *2 DISCHARGE HOSE SUB-ASSEMBLY *3 NO. 1 ENGINE UNDER COVER ...

    Removal
    REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFO-1234yf(R1234yf)) Click here 2. REMOVE NO. 1 ENGINE UNDER COVER Click here 3. REMOVE FAN AND GENERATOR V BELT ...

    Other materials:

    Toyota CH-R Service Manual > Wheel Opening Moulding(for Rear): Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL QUARTER OUTSIDE MOULDING HINT: When installing the quarter outside moulding, heat the vehicle body and quarter ou ...

    Toyota CH-R Service Manual > Manual Headlight Beam Level Control System: Precaution
    PRECAUTION EXPRESSIONS OF IGNITION SWITCH The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine Swit ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0067