Toyota CH-R Service Manual: Compressor(for Denso Made)

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL BLOWER RESISTOR (for Single Type) (a) Engage the guides and install the blower resistor as shown in the illustration. Install in this Directio ...

Components
COMPONENTS ILLUSTRATION *1 COMPRESSOR WITH PULLEY ASSEMBLY *2 DISCHARGE HOSE SUB-ASSEMBLY *3 NO. 1 ENGINE UNDER COVER ...

Other materials:

Toyota CH-R Service Manual > Vacuum Warning Switch: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during vacuum warning switch assembly removal/installation are shown below. Necessary Procedure After Part ...

Toyota CH-R Service Manual > Steering Column Assembly: Reassembly
REASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts. If the power steering ECU assembly is subjected to an impact, replace it with a new one. Do not pull the wire harness. Do not allow an ...

© 2017-2020 Copyright www.tochr.net
0.0195