Toyota CH-R Service Manual: Components

COMPONENTS

ILLUSTRATION

*1

COMPRESSOR WITH PULLEY ASSEMBLY

*2

DISCHARGE HOSE SUB-ASSEMBLY

*3

NO. 1 ENGINE UNDER COVER

*4

SUCTION HOSE SUB-ASSEMBLY

*5

O-RING

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

Non-reusable part

Compressor oil ND-OIL 12 or equivalent

-

-

    Compressor(for Denso Made)
    ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT COMPRESSOR WITH PULLEY ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Test ...

    Other materials:

    Toyota CH-R Service Manual > Steering Pad Switch: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering pad switch assembly removal/installation are shown below. Necessary Procedures After P ...

    Toyota CH-R Service Manual > Immobiliser System(w/ Smart Key System): Immobiliser System does not Operate Properly
    DESCRIPTION The immobiliser system compares the ID code that is registered to the certification ECU (smart key ECU assembly) with the ID code of the transponder chip that is embedded in the electrical key transmitter sub-assembly. WIRING DIAGRAM Refer to B2799. Click here CAUTION / NOTICE ...

    © 2017-2019 Copyright www.tochr.net
    0.0147