INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
(a) Install the washer motor and pump assembly as shown in the illustration.
|
Install in this Direction |
(b) Connect the connector.
(c) Connect the washer hose.
2. ADD WASHER FLUID
(a) Connect the rear washer hose.
(b) Add washer fluid to the washer jar.
3. INSTALL FRONT FENDER LINER RH
(a) Install the front fender liner RH with the 7 clips and 5 screws.
|
(b) Install the pin hold clips as shown in the illustration. NOTICE: Insert each pin hold clip with the slot aligned vertically. Do not rotate the pin hold clip after inserting it. After installation, confirm that the slot is aligned vertically. |
|
4. INSTALL ROCKER PANEL MOULDING RH
Click here
5. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH
Click here
6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
(a) Install the front wheel opening extension pad RH with the 5 screws.
7. INSTALL FRONT WHEEL RH
Click here
Removal
Washer Nozzle(for Front Side)Toyota CH-R Service Manual > Tire Pressure Warning System: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC (for TIRE PRESSURE WARNING ECU AND RECEIVER) (USING Techstream)
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / Tire Pressure Monitor / ...
Toyota CH-R Owners Manual > Side doors: Unlocking and locking the doors from the inside
Door lock switches
Locks all the doors
Unlocks all the doors
Inside lock buttons
Locks the door
Unlocks the door
The front doors can be opened by pulling the inside handle even if the lock buttons
are in the lock position.
Locking the doors from the outside without a key ...