REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL RH
Click here
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
|
(a) Remove the 5 screws and front wheel opening extension pad RH. |
|
3. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH
Click here
4. REMOVE ROCKER PANEL MOULDING RH
Click here
5. REMOVE FRONT FENDER LINER RH
|
(a) Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clips. |
|
(b) Remove the 6 screws, 6 clips and front fender liner RH.
6. DRAIN WASHER FLUID
|
(a) Disconnect the rear washer hose from the windshield washer motor and pump assembly, and drain the washer fluid. HINT: Use a container to collect the washer fluid. |
|
7. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
(a) Disconnect the washer hose.
|
Remove in this Direction |
(b) Disconnect the connector.
(c) Remove the windshield washer motor and pump assembly as shown in the illustration.
Inspection
InstallationToyota CH-R Service Manual > Power Steering System: Precaution
PRECAUTION
IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine S ...
Toyota CH-R Service Manual > Outer Rear View Mirror: Components
COMPONENTS
ILLUSTRATION
*A
for Driver Side
*B
for Front Passenger Side
*C
for TMMT Made
*D
for TMC Made
*1
FRONT DOOR BELT SEAL
*2
FRONT DOOR GLASS INNE ...