Toyota CH-R Service Manual: Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE COOLER DRYER (for VALEO Made)

(a) Using a T55 "TORX" socket wrench, remove the cap from the modulator.

*a

Modulator

(b) Using needle-nose pliers, remove the cooler dryer from the modulator.

*a

Modulator

2. REMOVE COOLER DRYER (for DENSO Made)

(a) Using a 14 mm straight hexagon, remove the cap from the modulator.

*a

Modulator

(b) Using needle-nose pliers, remove the cooler dryer from the modulator.

*a

Modulator

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL COOLER DRYER (for VALEO Made) (a) Using needle-nose pliers install a new cooler dryer to the modulator. ...

    Other materials:

    Toyota CH-R Service Manual > Theft Deterrent / Keyless Entry: Relay
    Inspection INSPECTION PROCEDURE 1. INSPECT SECURITY WARNING RELAY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition S ...

    Toyota CH-R Service Manual > Pre-collision System: Brake Control Signal Mismatch (C1A69)
    DESCRIPTION The skid control ECU (brake actuator assembly) sends signals to the millimeter wave radar sensor assembly according to the brake control status. If the millimeter wave radar sensor assembly receives a VSC system malfunction signal from the skid control ECU (brake actuator assembly ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0093