REASSEMBLY
PROCEDURE
1. INSTALL COOLER DRYER (for VALEO Made)
(a) Using needle-nose pliers install a new cooler dryer to the modulator. |
|
(b) Apply sufficient compressor oil to the O-ring. Compressor Oil: VC100YF or equivalent NOTICE: Keep the O-rings and O-ring fitting surfaces free from dirt or foreign matter. |
|
(c) Using a T55 "TORX" socket wrench, install the cap to the modulator. Torque: 11 N·m {112 kgf·cm, 8 ft·lbf} |
|
2. INSTALL COOLER DRYER (for DENSO Made)
(a) Using pliers, install a new cooler dryer to the modulator. |
|
(b) Sufficiently apply compressor oil to the 3 O-rings and fitting surfaces of a new cap. Compressor Oil: ND-OIL 12 or equivalent NOTICE: Keep the O-rings and O-ring fitting surfaces free from dirt or foreign matter. |
|
(c) Using a 14 mm straight hexagon, install the cap to the modulator. Torque: 4.0 N·m {41 kgf·cm, 35 in·lbf} |
|
Toyota CH-R Service Manual > Vehicle Stability Control System: Slip Indicator Light does not Come ON
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination
meter assembly via CAN communication.
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform system
variant learning.
Click here
PROCEDURE
...
Toyota CH-R Service Manual > Rear View Monitor System: Image from Camera for Rear View Monitor is Abnormal
DESCRIPTION
The video signal of the rear television camera assembly is transmitted to the
radio and display receiver assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio and display receiver assembly, always replace
it with a new one. If a radio and ...