INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for Front Side)
HINT:
This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly.
(a) Fill the windshield washer jar assembly with washer fluid.
(b) Check that washer fluid flows from the windshield washer jar assembly. OK:
If the result is not as specified, replace the windshield washer motor and pump assembly. |
|
2. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (for Rear Side)
HINT:
This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly.
(a) Fill the windshield washer jar assembly with washer fluid.
(b) Check that washer fluid flows from the windshield washer jar assembly. OK:
If the result is not as specified, replace the windshield washer motor and pump assembly. |
|
Toyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): AV Signal Stoppage (Low Battery Voltage) (B158F)
DESCRIPTION
This DTC is stored when a video or audio signal is interrupted due to battery
voltage input to the radio and display receiver assembly dropping temporarily.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
B158F
...
Toyota CH-R Service Manual > Airbag System: Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
DESCRIPTION
The driver side squib 2nd step circuit consists of the airbag sensor assembly,
spiral cable with sensor sub-assembly and horn button assembly.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment
conditions are met.
These DTCs are stored when a malfunc ...