PROBLEM SYMPTOMS TABLE
HINT:
Symptom |
Suspected Area |
Link |
---|---|---|
Electric parking brake does not operate |
Proceed to "Electric Parking Brake does not Operate" |
|
Parking brake indicator light does not illuminate (red) or turn off when parking brake is manually engaged and disengaged |
Proceed to "Electric Parking Brake does not Operate" |
|
Electric parking brake AUTO function (shift-linked function) does not operate (shift-linked parking brake does not lock or release) |
Proceed to "Electric Parking Brake AUTO Function Circuit" |
|
AUTO indicator light does not change (does not illuminate or turn off) when mode switching (AUTO or manual) is performed |
Proceed to "Electric Parking Brake AUTO Indicator Light Circuit" |
|
Electric parking brake switch indicator light on electric parking brake switch (electric parking brake switch assembly) does not illuminate or turn off when lock and release operations are performed |
Electric parking brake switch indicator light drive circuit HINT: When a malfunction occurs, the AUTO indicator light also does not illuminate or turn off. |
|
Wire harness or connector (electric parking brake switch (electric parking brake switch assembly) - skid control ECU (brake actuator assembly)) |
- |
|
Electric parking brake switch (electric parking brake switch assembly) |
|
|
Skid control ECU (brake actuator assembly) |
|
Toyota CH-R Service Manual > Vehicle Stability Control System: Zero Point Calibration of Acceleration Sensor Undone (C1336)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the yaw
rate and acceleration sensor (airbag sensor assembly) via CAN communication.
The airbag sensor assembly has a built-in yaw rate and acceleration sensor and
detects the vehicle's condition using 2 circu ...
Toyota CH-R Service Manual > Front Lower Ball Joint: Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY
(a) Inspect the turning torque of the ball joint.
(1) Secure the front lower ball joint assembly in a vise using aluminum
plates.
(2) Install the nut to the front lower ball joint assembly stud.
(3) Using a to ...