If you perform maintenance by yourself, be sure to follow the correct procedure as given in these sections.
Items | Parts and tools |
Battery condition |
|
Brake fluid level |
|
Engine coolant level |
|
Engine oil level |
|
Fuses |
|
Light bulbs |
|
Radiator and condenser |
- |
Tire inflation pressure |
|
Washer fluid |
|
■When working on the engine compartment
Fuel and battery fumes are flammable.
■When working near the electric cooling fan or radiator grille Vehicles without a smart key system: Be sure the engine switch is off. With the engine switch in the "ON" position, the electric cooling fan may automatically start to run if the air conditioning is on and/or the coolant temperature is high. Vehicles with a smart key system: Be sure the engine switch is off. With the engine switch in IGNITION ON mode, the electric cooling fan may automatically start to run if the air conditioning is on and/or the coolant temperature is high.
■Safety glasses Wear safety glasses to prevent flying or falling material, fluid spray, etc., from getting in your eyes.
■If you remove the air cleaner filter Driving with the air cleaner filter removed may cause excessive engine wear due to dirt in the air.
Toyota CH-R Service Manual > Pre-collision System: ECU Power Source Circuit
DESCRIPTION
This circuit supplies power to the millimeter wave radar sensor assembly when
the ignition switch is ON.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
...
Toyota CH-R Service Manual > Rear Door Lock: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
the rear door lock with motor assembly removal/installation are shown below.
Necessary Procedure ...