Toyota CH-R Service Manual: Lost Communication with Power Source Control (B278C)

NOTICE:

• When using the Techstream with the ignition switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
• If the certification ECU (smart key ECU assembly) or ID code box (immobiliser code ECU) is replaced, refer to Registration.

  Click here

Rear Door LH ECU Communication Stop (B2324)

DESCRIPTION This DTC is stored when LIN communication between the power window regulator motor assembly (for rear LH door) and main body ECU (multiplex network body ECU) stops for 10 seconds or m ...

Front Passenger Side Door ECU Communication Stop (B2322)

DESCRIPTION This DTC is stored when LIN communication between the power window regulator motor assembly (for front passenger door) and main body ECU (multiplex network body ECU) stops for 10 seco ...

Other materials:

Toyota CH-R Service Manual > Center Airbag Sensor Assembly: Components
COMPONENTS ILLUSTRATION *A w/ Rear Air Duct - - *1 AIRBAG SENSOR ASSEMBLY *2 REAR NO. 2 AIR DUCT Tightening torque for "Major areas involving basic vehicle performance ...

Toyota CH-R Service Manual > Navigation System: Voice Recognition Microphone Disconnected (B1579)
DESCRIPTION The radio and display receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines. This DTC is stored when a microphone connection detection signal line is disconnected. DTC ...