Components
COMPONENTS
ILLUSTRATION
*1 |
SHIFT LEVER CAP |
*2 |
SHIFT LEVER KNOB SUB-ASSEMBLY |
Removal
REMOVAL
PROCEDURE
1. REMOVE SHIFT LEVER CAP
Click here
2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Remove in this Direction |
(a) Disengage the 2 claws to disconnect the shifting hole cover sub-assembly as shown in the illustration.
(b) Using a screwdriver, expand the LH side clip and pull out the shift knob from the floor shift shift lever assembly as shown in the illustration.
*1 |
Clip |
Remove in this Direction |
Installation
INSTALLATION
PROCEDURE
1. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
(a) Install the shift lever knob sub-assembly to the floor shift shift lever assembly.
(b) Engage the 2 claws to connect the shifting hole cover sub-assembly.
2. INSTALL SHIFT LEVER CAP
Click here
Toyota CH-R Service Manual > Airbag System: Short in Curtain Shield Squib LH Circuit (B1835/58-B1838/58)
DESCRIPTION
The curtain shield squib LH circuit consists of the airbag sensor assembly and
curtain shield airbag assembly LH.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment
conditions are met.
These DTCs are stored when a malfunction is detected in the curta ...
Toyota CH-R Service Manual > Front Door Outside Moulding: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR OUTSIDE MOULDING
(a) Remove the peeling paper from the face of the outside moulding retainer.
HINT:
Af ...