Toyota CH-R Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL BLIND SPOT MONITOR BUZZER

(a) Connect the connector.

(b) Engage the clamp to install the blind spot monitor buzzer.

2. INSTALL FUSE BOX OPENING COVER

Click here

3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

5. INSTALL COWL SIDE TRIM BOARD LH

Click here

6. INSTALL FRONT DOOR SCUFF PLATE LH

Click here

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ...

    Rear View Monitor System
    ...

    Other materials:

    Toyota CH-R Service Manual > Airbag System: Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
    DESCRIPTION The driver side squib 2nd step circuit consists of the airbag sensor assembly, spiral cable with sensor sub-assembly and horn button assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunc ...

    Toyota CH-R Service Manual > Back Door Outside Garnish: Installation
    INSTALLATION PROCEDURE 1. INSTALL NO. 2 BACK DOOR GARNISH RETAINER (a) Engage the claws to install the No. 2 back door garnish retainer as shown in the illustration. Install in this Direction 2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (a) Remove the rele ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.1697