INSTALLATION
PROCEDURE
1. INSTALL OIL PRESSURE SENSOR
(a) Apply Toyota Genuine CVT fluid FE to the O-ring of the oil pressure sensor.
NOTICE:
If reusing the oil pressure sensor, check that the O-ring is not damaged.
|
(b) Using SST, install the oil pressure sensor to the continuously variable transaxle assembly. SST: 09326-22011 Torque: Specified tightening torque : 20.6 N·m {210 kgf·cm, 15 ft·lbf} HINT:
|
|
(c) Connect the oil pressure sensor connector.
2. INSTALL REAR ENGINE UNDER COVER LH
Click here
3. INSTALL NO. 1 ENGINE UNDER COVER
Click here
4. INSTALL FRONT WHEEL LH
Click here
5. RESET MEMORY
Click here
RemovalToyota CH-R Service Manual > Power Steering System: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTCs (USING TECHSTREAM)
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / EMPS / Trouble Codes.
Chassis > EMPS > Trouble Codes
(f) Ch ...
Toyota CH-R Service Manual > Lighting System: Daytime Running Light Relay Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) controls the daytime running lights.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing
the following procedure.
Before replacing the main body ECU (m ...