Toyota CH-R Service Manual: Oil Pressure Sensor

Installation

INSTALLATION PROCEDURE 1. INSTALL OIL CLEANER (CVT) MAGNET (a) Install the 2 oil cleaner (CVT) magnets to the transaxle oil (CVT) pan sub-assembly. ...

Components

COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER *2 REAR ENGINE UNDER COVER LH N*m (kgf*cm, ft.*lbf): Specified torque ...

Other materials:

Toyota CH-R Service Manual > Lumbar Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT LUMBAR POWER SEAT SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condit ...

Toyota CH-R Service Manual > Blind Spot Monitor System: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION This DTC is stored when a beam axis adjustment has not been performed for the blind spot monitor sensor RH (Slave). HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis adjustment is performed. Completin ...