INSTALLATION
PROCEDURE
1. INSTALL OIL CLEANER (CVT) MAGNET
(a) Install the 2 oil cleaner (CVT) magnets to the transaxle oil (CVT) pan sub-assembly. |
|
2. INSTALL TRANSAXLE OIL (CVT) PAN SUB-ASSEMBLY
(a) Clean the transaxle oil (CVT) pan sub-assembly installation surface of the continuously variable transaxle assembly.
(b) Install a new transaxle oil pan (CVT) gasket to the transaxle oil (CVT) pan sub-assembly.
(c) Install the transaxle oil (CVT) pan sub-assembly to the continuously variable transaxle assembly with the 19 bolts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(d) Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle oil (CVT) pan sub-assembly.
Torque:
1.7 N·m {17 kgf·cm, 15 in·lbf}
(e) Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug to the transaxle oil (CVT) pan sub-assembly.
HINT:
Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.
(f) Using a 10 mm hexagon socket wrench, install a new gasket and drain plug to the transaxle oil (CVT) pan sub-assembly.
Torque:
49 N·m {500 kgf·cm, 36 ft·lbf}
3. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
Click here
4. INSPECT FOR FLUID LEAK
5. INSTALL REAR ENGINE UNDER COVER LH
Click here
6. INSTALL NO. 1 ENGINE UNDER COVER
Click here
Toyota CH-R Service Manual > Can Communication System: Check Bus 1 Line for Short to +B
DESCRIPTION
There may be a short circuit between one of the CAN bus lines and +B when no
resistance exists between terminal 23 (CA1H) of the central gateway ECU (network
gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 8 (CA1L) of the central
gateway ECU (network gateway ECU) and t ...
Toyota CH-R Service Manual > Rear Door Courtesy Switch: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Using a T30 "TORX" socket wrench, install the rear door cou ...